Installation Guide

7)
Support Bar Installation
(#6)
Set the bar on the glass and posi-
tion it against the wall, keeping it horizon-
tally level.(support bar does not need
cut). Mark where the mounting screw hole
needs drilled. Set bar aside and drill wall
with a 1/4” masonry drill bit. Insert wall
anchor and fasten bracket to wall with
screw provided. Attach support bar into
bracket and slip other end over glass.
Tighten Allen set screws on wall bracket.
Tighten screw against the glass on glass
bracket. Example 16.0.
8) Seal inside and out with 100% sili-
cone all around fixed panel, sealing gap
where u-channel meets tile and the gap
between glass and u-channel.
Example 17.0.
9) Finally, add ZV914 vinyl (#10) and
MAG4038 (#4) to door by firmly pressing
against door edge.
Example 18.0.
Example 16.0. Example 17.0.
Example 18.0.