Installation Guide

B) Last apply the “L” seal with VHB to the
tile by peeling off the protective coating
on the VHB tape and firmly applying it to
the tile. Making sure to correspond the
location of the “L” seal with the marks on
the tile made earlier in step A).
Example 10.1 (it’s a good idea to press
the inside of the “L” seal with your thumb
and run it down the length of the wall to
help make sure that sufficient contact be-
tween the VHB tape, “L” seal, and tile are
made). Allow 72 hours for full adhesion.
Example 10.1
wall
Ifyouropeningrequiresapanelinadditionto
thedoorusetheScottsdale Inline Panel
Instructionsthatfollow.
Note: bulb seal can be applied to the hinge side of
the door in the same way the “L” seal is applied.
Apply bulb seal to the glass and NOT the tile.
Example 10.0