Installation Guide

1) Mounting hinges (#1): The glass

and gaskets should be free of grime,

grease, oils or anything else that would

prevent the hinge and gasket from making

good contact with glass. Use glass cleaner

to remove these things. Remove the cover

plates and screws from the hinges. See

the template sheet in the hinge box for

the proper gasket to be used with your

selected glass thickness (included with

hinges). Apply the proper thickness gas-

kets to both sides of the door around the

hinge cutouts. Apply light pressure so

they will stay in place. Now put the main

body of the hinge in the glass cutout. The

back plate mounting screws will be to-

wards the inside of the shower. Align the

hinge in the cutout being sure that is cen-

tered up and down, and that there is

1/16”-3/32” gap between the back plate

and glass edge. After everything is

aligned, secure the inside cover plates

with the supplied machine screws (#12).

Note: Always tighten machine screws

by hand! You can use the #4 metric

Allen Wrench provided or you can use

your own. When tightening the screws

alternate from one screw to the other so

the pressure is evenly applied to the in-

side cover plate. Repeat the above pro-

cess on the additional hinge(s).

Example 1.0

Installation Instructions

for

Scottsdale

Pleasereadthroughalloftheinstructionstogetanover‐viewbeforeyouinstalltheshowerdoor.

ArizonaShowerDoorInc.reservestherighttoalter,modifyorredesignproductsatanytimewithoutpriornotice.

Forthemostcurrentversionsofallourinstallationinstructionspleasevisitwww.arizonashowerdoor.com