Installation Guide

4) To install wall channel drill three
3/16” holes approximately 16” apart in
backside of wall channel (the same way
you did for bottom channel) (#9) . Stack
wall channel on top of base channel
Example 13.0. then use a level to set
plumb. Then mark the holes on the wall.
Set channel aside then drill holes with a
3/16” masonry drill bit. Insert 3/16” ex-
pandable plug anchors then, secure the u-
channel by using #8x1” flathead screws.
Apply a blob of silicone in the inside cor-
ner of u-channel covering area where
metal meets wall for sealing.
5)
After u-channel is set, place two 1/4”
setting blocks in channel 1” from each end
(#13). Place glass into wall channel and
down into bottom channel and use a level
to check alignment. Example 14.0.
Glass panel should be plumb and level and
should be flush with open end of the u-
channel which should leave 1/4” between
the door glass and inline glass.
6) ) Measure from the curb to the top of
the fixed panel. Example 15.0. Apply the
ZVP043884MAG seal to the fixed panel by
firmly applying it to the glass edge (#3).
Example 15.1. Notch ZVP043884MAG
strike to fit bottom channel.
Example 13.0.
Example 14.0.
Example 15.0.
Example 15.1.