Installation Manual

RMVESAMPS | Robust AMPS Mount with VESA 75/VESA 100 Compatible Head
!
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and / or
air bag deployment.
Arkon is not responsible for any damages caused to your vehicle, your
device, or yourself due to the installation or use of this mount.
Consumer Hotline:
USA [phone]
INT ’L [phone]
Monday - Friday 9 am - 5 pm, PST
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in Taiwan
© Copyright 2017 Arkon Resources, Inc.
The Mobile Mounting Specialists™
Loosen adjustment knob to adjust angle of pedestal and position
of VESA plate. Tighten to secure.
Attach any VESA 75/VESA 100 compatible device or holder (not
included, sold separately) to the VESA plate.
3 4
2
Attach APMAMPS25MM and AP25MMVESA adapters to the mount
shaft as shown by loosening knob. Tighten to secure.
1
APMAMPS25MM
AP25MMVESA
SP-RM200 APMAMPS25MM AP25MMVESA
Package Contents:
(1) SP-RM200 – Robust Mount Shaft
(1) APMAMPS25MM – Metal 4-Hole AMPS to 25mm Adapter
(1) AP25MMVESA – 25mm Ball to VESA 75/VESA 100
Attach the pedestal to the mounting surface through the
AMPS base plate. Choose the screws (not included) that will
work best on the chosen mounting surface.
rev.102717
AP
25
AP25
Adjustment Knob