DHP380A 2.4GHz Digital Wireless Headphone User Manual Please read before using this headphone.
INTRODUCTION This 2.4GHz Digital Wireless Headphone uses latest digital wireless technology that enables you to enjoy crystal sound stereo music and TV sound anywhere inside your home. Simply connect the transmitter to a desired audio source: DVD player, CD player, TV set, VCR , Hi-Fi system, or iPod. Without complicated wiring and installation, the system enables you to enjoy thrilling, lifelike sound in minutes. FEATURES 1. 2.4GHz Digital UHF Technology 2. 31-Channel Frequency Hopping System 3.
COMPONENT PART LIST A) Transmitter 1. Power / Audio Signal & Charging indicator 2. Charging pins 3. Audio IN socket 4. DC IN socket B) Headphone Receiver 5. Volume Up and Down Control 6. Signal link LED indicator 7. Charging contacts 8. ON/OFF Control 9. Power LED indicator C) Accessories 10. RCA cable 11. NiMH AAA size batteries for Headphone (2 pieces) 12.
INSTALLATION TRANSMITTER 1. Connect the supplied AC/DC power adaptor to an electrical wall outlet. 2. Plug the AC/DC power adaptor in the DC jack located on the rear of the transmitter. The red Power/Audio Signal LED start to flash for around 6 seconds. 3. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV, DVD, VCD, VCR, Hi-Fi, iPod and MP3 player. Plug the adaptor in the AC source and connect the audio plug to the audio source.
OPERATION TRANSMITTER Turn on the audio source (TV or audio component) to which the transmitter is connected with. The Power / Signal LED on the transmitter will start light on in red when it receives the audio signal. HEADPHONE RECEIVER 1. Turn on the headphone by pressing and hold the Power button around 1 second. The POWER LED (Red) will light up, the SIGNAL LED (Green) will be flashing until signal link between transmitter and receiver is established 2.
4. Charging the batteries a) Turn OFF the headphone by pressing and hold the Power button around 1 second . b) Retract the cabinet hanger back to the Headband. c) Place the headphone on the transmitter's charging cradle. The charging process begins automatically, and the charging LED will light up in green when the charging contacts of transmitter and headphone are made successfully.
prongs on the transmitter cradle. Depends on the capacity of the rechargeable battery to be used, the battery charging process will be around 5 to 7 hours. This device must be used with the AC/DC adaptor supplied in the package. WARNING: Never attempt to recharge conventional dry cells. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.