Instructions / Assembly

Consumer Hotline:
USA [phone]
INT’L [phone]
Monday - Friday 9 am - 5 pm, PST
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in Taiwan & China
© Copyright 2015 Arkon Resources, Inc.
The Mobile Mounting Specialists™
Attach holder to mount by inserting the Dual T-Tabs of the
mount into the holder and sliding the holder down to lock.
2
3
Attach mount to windshield and engage suction lock lever.
1
Package Contents:
SM060-2 – Slim-Grip® Ultra™ Holder
CM017-KST-2SH – 5” Robust Base Windshield Suction Pedestal
AP020 – Adhesive Dashboard Mounting Disk
IMPORTANT: Select the appropriate short or long support legs and
install to holder. For large sized smartphones such as the Galaxy Note
and midsize tablets, select 4 long support legs.
SM617-IPM617 | Slim-Grip® Ultra™ Robust Windshield & Dashboard Mount
rev.020515
Insert device by pushing down on the lower support legs and
engaging the spring-loaded mechanism. Adjust support legs
as necessary. OPTIONAL: Use included adhesive disk for dashboard mounting.
Safety Precaution
Arkon is not responsible for any damages caused to your vehicle, your device, or
yourself due to the installation or use of this mount. Do not install Arkon products
over an air bag cover or within the air bag deployment zone. Arkon Resources, Inc.
assumes no responsibility of liability for injury or death as a result of car crashes
and or air bag deployment.
Suction Lock
Lever
AP020
SM060-2
CM017-KST-2SH
K
K
K
K
K
K
K
K
K
K
Slide legs to adjust
Adjustment
Knob
Adhesive
Disk
Push down on
lower legs to
mount device
NOTE: If necessary, use included long legs for large devices or cases. NOTE: Let adhesive cure for 24 hours before use.
!