MSDS
SAFETY DATA SHEET
SDS Name:
Zinc Die Casting Alloys
Pg:5 of 5
* reporting not required when diameter of the pieces of solid metal released is equal to or exceeds 100 micrometers
(0.004 inches).
EPCRA Section 302 Extremely Hazardous Substance: ........................... No Ingredients Qualify
EPCRA Section 311/312 Hazard Categories: ........................................... No Hazard Categories Apply
EPCRA Section 313 Toxic Release Inventory: ......................................... This product does not contain any toxic
chemicals
subject to the Toxic Release reporting requirements. However, potential by-products from working with this product,
"Zinc (Fume or Dust)" CAS 7440-66-6 and “Aluminum (Fume or Dust)” CAS 7429-90-5 are reportable.
CANADIAN:
Ingredients Listed on DSL: ................................................. ...................... Yes
WHMIS Classification: .............................................................................. In ingot form, this product is not a Controlled
Product under the CPR.
EUROPEAN UNION:
Ingredients Listed on the European Inventory of Existing
Commercial Chemical Substances (EINECS): ......................................... Yes
EU GHS CLP Classification: .................................................................. Neither zinc nor aluminum is classified.
16. Other Information
History
Date of issue
3/25/2014
Revision date
Revision #
This document has been prepared in accordance with the SDS requirements of the OSHA Hazard Communication Standard
29 CFR 1910.1200.
Each of the products covered by this document is considered an article in its final form and not subject to the requirements
for classification or labeling under 29 CFR 1910.1200.
Notice to Reader
To the best of our knowledge, the information contained in this Safety Data Sheet is accurate and reliable and reasonable
precautions have been taken in the preparation of the data contained herein. It is offered solely for your information,
consideration and investigation. Eastern Alloys, Inc. and its subsidiaries extend no warranty and assume no responsibility
for the accuracy of the content and expressly disclaims all liability for reliance thereon. This safety data sheet provides
guidelines for the safe handling and processing of this product; it does not and cannot advise on all possible situations.
Therefore, your specific use of this product should be evaluated to determine if additional precautions are required. This
Safety Data Sheet shall not constitute a guarantee for any specific product features. Determination of suitability of this
material is the sole responsibility of the user. All materials may present unknown hazards and should be used and handled
with caution and following reasonable safety procedures. Consequently the buyer assumes all risks in connection with the
use and handling of this material.