Owner Manual

Wood Arc Hammock Stand

Weight Limit: 300 lbs

Congratulations on purchasing wood arc

hammock stand to be used with most 11 ft ,

2-pt hammocks. We hope it helps provide

hours of relaxation. If you have questions

regarding this product, please contact us.

Hardware:

Part A – Hardware Bag

Part B - #17 by 7”L bolts (x 4)

Part C - #17 by 5 ½”L bolts (x 4)

Part D - #17 washers (x 18)

Part E - #17 lock nuts (x 10)

Part F – Carabiner clip (x 4)

Part G – Eye bolt (x 2)

Part H – 15 link chain (x 2)

Part I – 2-piece #17 wrench (x 2)

Wood Parts:

Part J – Legs (x 2)

Part K – Center braces (x 2)

Part L – Uprights (x 2)

Assembly can accomplished with one person, but for easier assembly a

second person is recommended.

PAGE 1
Wood Arc Hammock Stand Weight Limit: 300 lbs C B Congratulations on purchasing wood arc hammock stand to be used with most 11 ft , 2-pt hammocks. We hope it helps provide hours of relaxation. If you have questions regarding this product, please contact us.
PAGE 2
Step 1: Locate the stand legs (Part J) and place on level surface about 3 ½ feet apart as in figure 1. The beveled edges on the bottom of the legs should face each other Beveled foot edges should face inward toward the other leg. Beveled edge Detail Step 2: Locate center braces (Part K) and place on top of the legs (Part J) so that the ends of the braces curve upward as in figure 2, and the larger counter sink holes of the center braces are facing the outside.
PAGE 3
Step 4: With the uprights now in place, tighten the bolts that connect the legs (Part J) to the center braces (Part K) using the included wrenches (Part I) as shown in Figure 8. Figure 8 Step 5: Locate the eye-bolts (Part G) and place through the hole on the top of the upright (Part L) with the eye facing the inside of the stand as in Figure 9. Place a washer (Part D) then a lock-nut (Part E) onto the threaded end of the eye-bolt as in Figure 10.