Use and Care Manual

ManualsBrandsArlo Blinds ManualsBlindsWhite Cordless Room Darkening Faux Wood Blind with 2 in. Slats 34.25 in. W x 60 in. L (Actual Size)

2” Cordless Faux Wood Blind

Installation Instructions

Congratulations on purchasing one of the

best blinds on the market. You can take

pride that your purchase will enhance the

function and beauty of your home.

Components

(Note: Support brackets are included for

blinds that have a width that is over 37".

Mounting Instructions

Select the type of mount that

best suits your preference.

Inside mount: inside the

window frame.

Outside mount: outside the

window frame.

Overhead surface/ceiling

mount. The brackets should be

placed closer to the ends of the

headrail so that the headrail is

secured firmly to the brackets.

SUPPORT BRACKET

Position the support brackets as

evenly as possible between the

mounting brackets so that the

blind is evenly secured.Make

sure the support bracket is in

line with the End Mounting

brackets.

INSERTING HEADRAIL

Insert the headrail into

the brackets and lock

the hinged flaps down

to hold the headrail in

position.

For an inside mount

installation, insert the

valance clips into the

valance groove located on

the backside of the valance.

Afterwards, make sure the

valance clip is securely

fastened to the headrail

before using your blind.

For an outside mount/ceiling mount installation, insert the

valance clips into the valance groove located on the

backside of the valance. Then attach the valance clip to

the headrail. Afterwards, insert the return clip into the

valance return. Note that the insert clip needs to attach to

the mitered (angle cut) side of the valance return for

proper installation. Finally, you have the option to attach

the valance return assembly to the valance ends for the

complete valance.

Keep your blind looking its best by periodically cleaning it with either a soft cloth, feather duster, dusting mitt or the brush attachment

from a vacuum cleaner. Please avoid using solvents or abrasive solutions to clean the blind since this may damage the blind.

Once you finish the

installation, lower the blind

and check that the blind is

balanced.

Note: The blind should

not rebound and fall.

Hold Down Brackets(Optional)

Using two small screw, screw

hold down bracket to window

or wall . Snap bracletpin ends

into the hole at the bottom

rail end.

Note: the use of hold down

bracket is recommended but

is not a requirement for the

normal funtion of blind.

Tools recommended for installation