User Manual
10
Set Up Your System
If you use an existing Arlo Wire-free system, do not sync your Arlo Q camera to
your base station.
9. Press the Sync button on your camera until the blue LED starts blinking.
A slow blinking blue LED indicates that the camera is connecting to a WiFi
network. A fast blinking blue LED indicates that the camera is connecting to
Arlo servers.
10. Click or tap Continue.
11. Hold the QR code 4 to 8 inches (10 to 20 cm) in front of the camera until you
hear a chime sound.
12. Click or tap Yes if you heard a chime sound.
Click or tap No if you did not hear a chime sound.
13. Wait for the app to discover the Arlo Q camera.
If you did not hear a chime sound, try moving the camera closer to or farther
away from the QR code. If you hear a buzz sound, try the following remedies:
• Check to ensure that you entered the WiFi network name and password
correctly. The WiFi network name and password are case-sensitive.
• Try moving your Arlo Q camera closer to your WiFi router. Do not place your
camera farther than 300 feet (91 meters) from your WiFi router.
Note: For initial setup, you can place the camera in the same room as your WiFi router,
and then move the camera to another location aer you finish the setup. During setup,
the Arlo Q camera must connect to the same WiFi network that you plan to use later.
14. Choose a service plan.
For more information, see Subscription Plans on page 56.
Your Arlo account is set up.
Add a Camera From Another Arlo Account
¾ To add a camera from another Arlo account:
1. Tap the Arlo icon
on your mobile device.
You can also enter arlo.netgear.com in the address bar of a browser
The Cameras page displays.