User's Manual
Table Of Contents
- 1. Get Started
- 2. WiFi Setup and Connections
- 3. Camera Basics
- 4. Modes, Rules, and Alerts
- 5. Change Your Settings
- Two-step verification
- Use face or fingerprint authentication
- Customize your profile
- Change your Arlo password
- Reset a forgotten password
- Grant access to friends
- Change the time zone
- Camera settings
- Customize the camera spotlight settings
- Adjust the flicker setting
- View device information
- Remove a device from your account
- 6. Troubleshooting
28Modes, Rules, and Alerts
Essential Spotlight Camera
User Manual
• In urban environments, where the cell towers and WiFi routers are more dense, geofencing
accuracy can reach 100–200 meters.
Note: If you live in a skyscraper, geofencing might not work reliably due to GPS
inaccuracies. Using the Large radius setting might help.
• In rural areas, where cell towers and WiFi routers are sparse, geofencing accuracy can
reach several hundred meters.
To improve geofencing accuracy, make sure that your mobile device meets these conditions:
• WiFi is turned on.
• GPS or location services are turned on.
Prepare your mobile device for geofencing
1. Enable GPS or location services so that Arlo can locate your device.
2. Enable WiFi.
3. Download the Arlo app and log in on each mobile device that you plan to enable for
geofencing.
For Arlo Geofencing to work on your device, you must adjust the settings on your Android or
iOS mobile device as follows:
Android devices
• Location permission = On
• Location services = On
• Battery saver = O
• Data limit = O
• Airplane mode = O
iOS (Apple) devices
• Share my location = On
• Location services = Always
• Airplane mode = O
Set up geofencing for the rst time and set up modes
1. Open the Arlo app.
2. Tap Mode.
3. Select your camera.
DRAFT