User Manual
Table Of Contents
- 1. Get to Know Your Doorbell
- 2. Get Started
- 3. WiFi Setup and Connections
- WiFi connection options for your doorbell
- Tips for optimal WiFi performance
- Connect your mobile device to a 2.4 GHz WiFi network during setup
- Connect an optional Arlo SmartHub
- Connect an optional Arlo Base Station with Siren
- Move your doorbell’s WiFi connection to a SmartHub or base station
- Move your doorbell’s WiFi connection to a direct router connection
- 4. Optional Arlo Chime 2
- 5. Use Your Doorbell
- 6. View and Record Videos
- 7. Change Your Settings
- Two-step verification
- Use face or fingerprint authentication
- Customize your profile
- Change your Arlo password
- Reset a forgotten password
- Grant access to friends
- Change the time zone
- Doorbell settings
- Adjust the flicker setting
- Optional SmartHub and Base Station settings
- View device information
- Remove a device from your account
- Restart the doorbell from the Arlo app
- 8. Modes, Rules, and Alerts
- Arm or disarm all your Arlo devices
- Modes
- Select a mode
- Mute Notifications
- Rules for modes
- Trigger a Chime 2 when the doorbell is pressed
- Change motion sensitivity
- Automatically stop recording when motion stops
- Add a rule with a base station siren trigger
- Manage alerts
- Schedule when your doorbell camera is armed
- Set up Arlo Geofencing
- Geofencing with multiple mobile devices
- Use your doorbell to trigger a camera to record
- 9. SmartHub SD Card Local Storage
- 10. SmartHub or Base Station USB Local Storage
- 11. Arlo Connect
- 12. Troubleshooting
- The doorbell doesn’t scan the QR code in the Arlo app during setup
- Arlo doesn’t discover your doorbell during setup
- Use Bypass mode for the Power Kit
- Traditional chime doesn’t ring when I press the doorbell
- Doorbell LED doesn’t light
- Power interruption notification
- Remove the doorbell from its mount
- Reset the doorbell
- Can’t see video streams in a browser
- Not receiving push notifications
- Troubleshoot Arlo Geofencing
- Scan the QR code during Chime 2 setup
- Arlo doesn’t discover Chime 2 during setup
- Chime 2 doesn’t ring when the doorbell is pressed
- Reset your Arlo Chime 2
- Verify that an optional SmartHub or base station is online
- The SmartHub or base station is offline
- Reset a SmartHub to factory settings
- Reset a Base Station to factory settings
79Troubleshooting
Essential Video Doorbell Wired
User Manual
Power interruption notication
The push notication Power interruption at [TIME] means your doorbell is not currently
receiving any voltage or its wires have been disconnected, but your home’s WiFi and Internet
connection are still working.
If you have an Arlo Smart subscription, you can tap the notication to activate an alarm, call a
friend, or call e911.
When the power returns to your doorbell, wait about 10 minutes for the doorbell to come
back online. If your wired Arlo Essential Video Doorbell remains in this state longer than 20
minutes aer power is restored, try restarting your doorbell from within the Arlo app.
Remove the doorbell from its mount
Aer you install the wired Arlo Essential Video Doorbell, you can remove it from the mount so
that you can access the doorbell’s rear panel.
Use a paperclip or the release pin that came with your wired Arlo Essential Video Doorbell.
1. Press the release pin into the pin hole in the mount.
The doorbell releases with a click sound.
2. Remove the doorbell from the mount.
Release pin