User Manual
Table Of Contents
- 1. Get to Know Your Doorbell
- 2. Get Started
- 3. WiFi Setup and Connections
- WiFi connection options for your doorbell
- Tips for optimal WiFi performance
- Connect your mobile device to a 2.4 GHz WiFi network during setup
- Connect an optional Arlo SmartHub
- Connect an optional Arlo Base Station with Siren
- Move your doorbell’s WiFi connection to a SmartHub or base station
- Move your doorbell’s WiFi connection to a direct router connection
- 4. Optional Arlo Chime 2
- 5. Use Your Doorbell
- 6. View and Record Videos
- 7. Change Your Settings
- Two-step verification
- Use face or fingerprint authentication
- Customize your profile
- Change your Arlo password
- Reset a forgotten password
- Grant access to friends
- Change the time zone
- Doorbell settings
- Adjust the flicker setting
- Optional SmartHub and Base Station settings
- View device information
- Remove a device from your account
- Restart the doorbell from the Arlo app
- 8. Modes, Rules, and Alerts
- Arm or disarm all your Arlo devices
- Modes
- Select a mode
- Mute Notifications
- Rules for modes
- Trigger a Chime 2 when the doorbell is pressed
- Change motion sensitivity
- Automatically stop recording when motion stops
- Add a rule with a base station siren trigger
- Manage alerts
- Schedule when your doorbell camera is armed
- Set up Arlo Geofencing
- Geofencing with multiple mobile devices
- Use your doorbell to trigger a camera to record
- 9. SmartHub SD Card Local Storage
- 10. SmartHub or Base Station USB Local Storage
- 11. Arlo Connect
- 12. Troubleshooting
- The doorbell doesn’t scan the QR code in the Arlo app during setup
- Arlo doesn’t discover your doorbell during setup
- Use Bypass mode for the Power Kit
- Traditional chime doesn’t ring when I press the doorbell
- Doorbell LED doesn’t light
- Power interruption notification
- Remove the doorbell from its mount
- Reset the doorbell
- Can’t see video streams in a browser
- Not receiving push notifications
- Troubleshoot Arlo Geofencing
- Scan the QR code during Chime 2 setup
- Arlo doesn’t discover Chime 2 during setup
- Chime 2 doesn’t ring when the doorbell is pressed
- Reset your Arlo Chime 2
- Verify that an optional SmartHub or base station is online
- The SmartHub or base station is offline
- Reset a SmartHub to factory settings
- Reset a Base Station to factory settings
90Troubleshooting
Essential Video Doorbell Wired
User Manual
To reset a base station:
1. Use a straightened paper clip to press and hold the Reset button for about 10 seconds.
The base station resets.
The LED behavior during the reset depends on your base station model.
• The Base Station VMB4500 has one LED on the front. The LED blinks alternating blue
and amber.
• The Base Station VMB4000 has three LEDs on the front. The LEDs blink amber.
The base station reboots.
2. Wait for the base station to nish rebooting before you unplug it, turn it o, or use the Arlo
app to set it up.
3. To add the Base Station with Siren to your Arlo account and set it up, open the Arlo app
and tap New to Arlo?.
4. Follow the setup instructions.
If your Arlo cameras were synched or paired to the SmartHub, you might need to synch or
pair the cameras to the base station again.