User Manual
Table Of Contents
- 1. Get to Know Your Arlo Video Doorbell
- 2. Get Started
- 3. Use Your Video Doorbell
- 4. View and Record Videos
- 5. Change Your Settings
- Two-step verification
- Use face or fingerprint authentication
- Customize your profile
- Change your Arlo password
- Reset a forgotten password
- Grant access to friends
- Change the time zone
- Video Doorbell settings
- Adjust the flicker setting
- View device information
- Remove a device from your account
- Restart the Video Doorbell from the Arlo app
- 6. Modes, Rules, and Alerts
- 7. Troubleshooting
- Video Doorbell doesn’t scan the QR code in the Arlo app during setup
- The Arlo app doesn’t find the doorbell during setup
- Connect your mobile device to a 2.4 GHz WiFi network during setup
- Use Bypass mode for the Power Kit
- The chime doesn’t ring when I press the doorbell
- Video Doorbell LED doesn’t light
- Power interruption notification
- Remove the Video Doorbell from its mount
- Reset the Video Doorbell
- Can’t see video streams in a browser
- WiFi signal interference
- Not receiving push notifications
- Troubleshoot Arlo Geofencing
12Get Started
Video Doorbell
User Manual
Installing with an angled mounting plate depends on the position of the doorbell
and the walkway to your home. The angled mounting plate lets you install your
doorbell so that it is angled toward the left or angled toward the right.
4. Follow the instructions in the Arlo app to connect the wires and install your
doorbell.
5. Turn on power at the breaker.
6. Check the LED on the front of your Arlo Video Doorbell. See LED during setup on
page 14.
7. Connect your Arlo Video Doorbell to your home network’s 2.4 GHz WiFi.
Use the optional wire extensions
Two identical wire extensions and fasteners come in the package with your Arlo Video
Doorbell.
If the existing wires for your doorbell are too short to connect your Arlo Video
Doorbell, you can use the wire extensions and fasteners to lengthen the wires.
Fastener
Wire extension
Arlo Video
Doorbell
Mounting
plate
Angled
mounting wedge
(optional)