User Manual
Table Of Contents
- 1. Get to Know Your Arlo Video Doorbell
- 2. Get Started
- 3. Use Your Video Doorbell
- 4. View and Record Videos
- 5. Change Your Settings
- Two-step verification
- Use face or fingerprint authentication
- Customize your profile
- Change your Arlo password
- Reset a forgotten password
- Grant access to friends
- Change the time zone
- Video Doorbell settings
- Adjust the flicker setting
- View device information
- Remove a device from your account
- Restart the Video Doorbell from the Arlo app
- 6. Modes, Rules, and Alerts
- 7. Troubleshooting
- Video Doorbell doesn’t scan the QR code in the Arlo app during setup
- The Arlo app doesn’t find the doorbell during setup
- Connect your mobile device to a 2.4 GHz WiFi network during setup
- Use Bypass mode for the Power Kit
- The chime doesn’t ring when I press the doorbell
- Video Doorbell LED doesn’t light
- Power interruption notification
- Remove the Video Doorbell from its mount
- Reset the Video Doorbell
- Can’t see video streams in a browser
- WiFi signal interference
- Not receiving push notifications
- Troubleshoot Arlo Geofencing
20Use Your Video Doorbell
Video Doorbell
User Manual
4. Tap Breathe LED on Motion Detection to enable or disable this setting.
When Breathe LED is enabled, the LED lights in a slow breathing pattern when
motion is detected. When this setting is disabled, the LED remains off when
motion is detected.
5. Tap LED on Call Accepted to enable or disable this setting.
When this setting is enabled, the LED lights solid white when a video call is
accepted and active. When this setting is disabled, the LED remains off when a call
is accepted.
Change the call settings
1. Open the Arlo app.
2. Tap the gear icon next to the Arlo Video Doorbell.
3. Scroll down and tap Call Settings.
4. To turn the speaker on your mobile phone on and off, tap Speaker.
5. To mute the audio on your mobile phone, tap Mute.
6. To allow a visitor to leave a video message if you don’t accept a doorbell call after
20 seconds, or if you decline the call, tap Leave your message.
Turn the siren on and off
Your doorbell includes a siren that you can turn on to discourage tampering by an
unwanted visitor. With an Arlo Smart plan, you can activate the siren from the push
notication sent on motion detection.
1. Open the Arlo app.
2. Tap Siren
on the upper right.
3. Tap Activate Siren.
If you have multiple Arlo devices with sirens, you’re prompted to select a device.
4. Swipe the Siren icon to the right.
The siren remains active for ve minutes or until you turn it off.
5. To turn off the siren, tap the slider at the top of the Devices page.