User Manual
Table Of Contents
- 1. Get to Know Your Essential Series Camera
- 2. Get Started
- Use the Arlo app for installation and setup
- Charge your camera indoors
- Use the sync button to wake the camera
- Check the LED
- Find a good location for your camera
- Wall mount your camera
- Connect an optional Essential Solar Panel (sold separately)
- Test motion detection
- Position your camera to detect motion in specific areas
- Arm your camera to detect motion
- 3. WiFi Setup and Connections
- 4. Use Your Essential Series Camera
- 5. Modes, Rules, and Alerts
- Arm or disarm all your Arlo devices
- Modes
- Select a mode
- Mute Notifications
- Rules for modes
- Change motion sensitivity
- Control whether the spotlight turns on when motion is detected
- Use a rule to activate the camera’s siren
- Add a rule with an optional base station siren trigger
- Manage alerts
- Schedule when your camera is armed
- Set up Arlo Geofencing
- Geofencing with multiple mobile devices
- Custom modes
- 6. Change Your Settings
- Two-step verification
- Use face or fingerprint authentication
- Customize your profile
- Change your Arlo password
- Reset a forgotten password
- Grant access to friends
- Change the time zone
- Camera settings
- Video Settings
- Adjust the audio settings
- Adjust the flicker setting
- Restart the camera from the Arlo app
- View device information
- Remove a device from your account
- Optional SmartHub and Base Station settings
- 7. SmartHub SD Card Storage
- 8. SmartHub or Base Station USB Storage
- 9. Arlo Connect
- 10. Troubleshooting
15Get Started
Arlo Essential Series Wire-Free Camera
User Manual
Use camera positioning to aim your camera
Camera positioning is available only when the camera is not streaming, recording motion, or
using the Motion Detection test. During camera positioning, the camera streams video as fast
as possible, without buering. You can aim your camera while watching on your smartphone
and making near real-time adjustments to the camera position. This means that you might
see lower-quality video while you are positioning your camera.
To position your camera:
1. Open the Arlo app.
2. Tap Settings > My Devices.
3. Select the camera.
4. Tap Device Utilities > Camera Positioning.
The camera starts streaming video. The signal strength bar indicates the WiFi signal that
your camera is receiving at its current location.
Arm your camera to detect motion
When your camera is armed, it detects motion. You can control when your camera is armed
using these features:
• Arm or disarm all your Arlo cameras and devices. See
Arm or disarm all your Arlo devices on
page 28.
• Select a mode such as Armed, Disarmed, Schedule, or Geofencing. See Select a mode on
page 29.