'RFXPHQW 12 &37 5 6 'DWH 5HYLVLRQ 63(&,),&$7,21 )25 5()(5(1&( &XVWRPHU 1DPH $UOR 7HFKQRORJLHV 0RGHO 1DPH $ E 6 3 &HOO *& 6'& + 0RGHO 1R &HO[SHUW 1R &XVWRPHU 1R >$&&(37$1&(@ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ Accepted by: Date: ġ ġ ġ ġ ġ ġ &(/;3(57 (1(5*< &25325$7,21 1R *RQJ WK 5
ೌמЎҹڋ0অुቬᐕ߄!! ЎҹጓዸǺDQU.4S.T3984! ।ԛ!ހ ! ԛ!!অुВය!! ࢂցᡂ׳ ႝෳೕጄ! ڋ0অुᄔाᇥܴ!! 2.9!! B12!! 312:0903!! Gjstu!sfmfbtf!! ɍࢂ!!Ɏց!! 2.9!! B13!! 312:09027!! Npejgz!Tijqqjoh!Wpmubhf!ჹᔈ!TPD!௶ॊ!! ɍࢂ!!Ɏց!! 2.9!! B14!! 31320203:!! ཥቚԋࠔဦ! ɍࢂ!!Ɏց!! 2.9!! B15!! 31330905!! ཥቚԋࠔဦ :387111:8! ɍࢂ!!Ɏց! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ߄ൂጓዸǺRT.3E.112.
INDEX : 1. Scope 2. Type and Name 3. Rating 4. Performance and Test Condition 5. Protection Function 6. Terminal Specifications 7.
1. Scope Specifications described in sections apply to the GC-SDC-763740-010H rechargeable batteries supplied by Celxpert Energy Corporation. The battery described in these specifications is the battery pack, which consists of unit cells manufactured by Amperex Technology Limited 2. Type and Name Applied Product Name Rechargeable Li-Polymer Battery Pack Cell Type GC-SDC-763740-010H Cell Configuration 1 series BMU Solution bq27z561+bq298015 3 parallel (1S3P) 3.
4.1.3 Measuring Instruments and Devices (1) Dimension measurement is carried out using a caliper whose measuring range is from 0 mm to 300mm and the precision is 1/20 mm. (2) Voltage measurement is carried out using a DC voltmeter, which can measure from 0 V to 20 V. (3) The precision of the voltmeter is ±1mV and input impedance is more than 10MΩ. (4) Discharge is carried out using electronic load equipment. The precision of the current is ±0.5%.
5. Protection Function Built-in control circuit of BMU (Battery Management Unit) for safety. (Ta= 25°C) No Function Type Threshold 1 Cell Overvoltage protection 2 Cell UnderVoltage protection 3 Over charge current protection 4 Over discharge current protection mV Delay Time 1.0~1.5 Sec Threshold 2800±30 mV 115.2~172.8 mSec Delay Time Short protection Unit 4440±15 threshold 3.4~5.6 A time 5.6~10.5 mSec threshold 3.4~5.6 A Delay Time 5.6~10.
.Handling Instructions The following hazard alert signals and words must appear in user manuals and / or instructions for users. HANDLING INSTRUCTIONS FOR LI-POLYMER RECHARGEABLE BATTERY Please read and follow the handling instructions before using the battery. Improper use of the battery may cause heat generation, fire, explosion, damage, or capacity deterioration of the battery. WARNING 01.
05. Do not use any battery chargers not specified by the end product. Also, follow the charge conditions specified by the end product. If the battery is charged under other conditions (a high temperature, a high voltage/current, or an altered charger) not specified by the end product, the battery may become over-charged with an excessive current and cause heat, explosion, or fire with abnormal chemical reactions. 06. Do not use, charge, or leave the battery in a car under the blazing sun.
CAUTION 01. Do not put the battery in a microwave, oven, or high pressure container. Sudden heat may damage the seal of the battery and may cause heat generation, explosion, or fire of the battery. 02. Do not leave the battery in a charger or equipment if it generates an odor and/or heat, color and/or shape changed, electrolyte leaked, or any other abnormalities.
Document NO. CPT-3R-XXX Date : 2021/5/12 Revision 0.1 : SPECIFICATION FOR REFERENCE Customer Name: Arlo Technologies Model Name: A-14 (1S4P) (Cell: N18650CP) Model No.: Celxpert No. Customer No. 308-xxxxx-xx [ACCEPTANCE] Accepted by: Date: CELXPERT ENERGY CORPORATION No.128, Gong 5th Rd., Longtan Township, Taoyuan County 325, Taiwan (R.O.C.
TENTATIVE History of Revision Rev. Date 0.
TENTATIVE INDEX : 1. Scope 2. Type and Name 3. Rating 4. Performance and Test Condition 5. Protection Function 6. Terminal Specifications 7.
TENTATIVE 1. Scope Specifications described in sections apply to the N18650CP rechargeable batteries supplied by Celxpert Energy Corporation. The battery described in these specifications is the battery pack, which consists of unit cells manufactured by BAK Battery CO, LTD. 2. Type and Name Applied Product Name Cell Type Cell Configuration BMU Solution Rechargeable Lithium-Ion Battery Pack N18650CP 1 series 4 parallel BQ27Z561+R5486K532CM+R5437L303CA-TR 3.
TENTATIVE 4.1.4 Standard Charge Standard charge means 2.5A CC charge to 4.2V,then CV charge till charge current dealine to 268mA, in 25℃. 4.1.5 Standard Discharge Standard discharge means discharging at 2.5A down to 2.6V, in 25℃. 4.1.6 Cycle life Charge / Discharge condition Charge pack with 2.5A CC charge to 4.2V,then CV charge till charge current dealine to 268mA, rest for 10min, and discharge pack with 2.5A dischargeing current until pack voltage reaches 2.
TENTATIVE 5. Protection Function Built-in control circuit of BMU (Battery Management Unit) for safety .(Ta= 25°C) No Function 1 1'st Cell Overvoltage protection 2 2'nd Cell Overvoltage protection 3 Cell Undervoltage protection 4 Over charge current protection 5 Over discharge current protection 6 Short protection Type Threshold Delay Time Threshold Delay Time Threshold Delay Time Threshold Delay Time threshold time threshold Delay Time SPEC 4230±20 700~1300 4350±25 4.8~7.2 2600±35 14~26 3.
TENTATIVE 7. Handling Instructions The following hazard alert signals and words must appear in user manuals and / or instructions for users. HANDLING INSTRUCTIONS FOR LI-POLYMER RECHARGEABLE BATTERY Please read and follow the handling instructions before using the battery. Improper use of the battery may cause heat generation, fire, explosion, damage, or capacity deterioration of the battery. WARNING 01.
TENTATIVE 05. Do not use any battery chargers not specified by the end product. Also, follow the charge conditions specified by the end product. If the battery is charged under other conditions (a high temperature, a high voltage/current, or an altered charger) not specified by the end product, the battery may become over-charged with an excessive current and cause heat, explosion, or fire with abnormal chemical reactions. 06. Do not use, charge, or leave the battery in a car under the blazing sun.
TENTATIVE CAUTION 01. Do not put the battery in a microwave, oven, or high pressure container. Sudden heat may damage the seal of the battery and may cause heat generation, explosion, or fire of the battery. 02. Do not leave the battery in a charger or equipment if it generates an odor and/or heat, color and/or shape changed, electrolyte leaked, or any other abnormalities.
Document NO. CPT-3R-XXX Date : 2021/6/21 Revision 0.4 : SPECIFICATION FOR REFERENCE Customer Name: Arlo Technologies Model Name: A-14 (1S4P) (Cell: NCR18650GA) Model No.: Celxpert No. Customer No. 308-xxxxx-xx [ACCEPTANCE] Accepted by: Date: CELXPERT ENERGY CORPORATION No.128, Gong 5th Rd., Longtan Township, Taoyuan County 325, Taiwan (R.O.C.
TENTATIVE History of Revision Rev. Date 0.1 2021/4/13 TENTATIVE Note 0.2 0.3 0.4 2021/5/4 2021/5/12 2021/6/21 Modify item 3 Rating table follow BAK cell spec. Modify item Storage Temperature condition follow Pana cell spec. Modify Cell Surface Temperature: -20 ~ +80°C @ Max.
TENTATIVE INDEX : 1. Scope 2. Type and Name 3. Rating 4. Performance and Test Condition 5. Protection Function 6. Terminal Specifications 7.
TENTATIVE 1. Scope Specifications described in sections apply to the NCR18650GA rechargeable batteries supplied by Celxpert Energy Corporation. The battery described in these specifications is the battery pack, which consists of unit cells manufactured by Panasonic, LTD. 2. Type and Name Applied Product Name Cell Type Cell Configuration BMU Solution Rechargeable Lithium-Ion Battery Pack NCR18650GA 1 series 4 parallel BQ27Z561+R5486K532CM+R5437L303CA-TR 3.
TENTATIVE 4.1.4 Standard Charge Standard charge means 2.5A CC charge to 4.2V,then CV charge till charge current dealine to 268mA, in 25℃. 4.1.5 Standard Discharge Standard discharge means discharging at 2.5A down to 2.6V, in 25℃. 4.1.6 Cycle life Charge / Discharge condition Charge pack with 2.5A CC charge to 4.2V,then CV charge till charge current dealine to 268mA, rest for 10min, and discharge pack with 2.5A dischargeing current until pack voltage reaches 2.
TENTATIVE 5. Protection Function Built-in control circuit of BMU (Battery Management Unit) for safety .(Ta= 25°C) No Function 1 1'st Cell Overvoltage protection 2 2'nd Cell Overvoltage protection 3 Cell Undervoltage protection 4 Over charge current protection 5 Over discharge current protection 6 Short protection Type Threshold Delay Time Threshold Delay Time Threshold Delay Time Threshold Delay Time threshold time threshold Delay Time SPEC 4230±20 700~1300 4350±25 4.8~7.2 2600±35 14~26 3.
TENTATIVE 7. Handling Instructions The following hazard alert signals and words must appear in user manuals and / or instructions for users. HANDLING INSTRUCTIONS FOR LI-POLYMER RECHARGEABLE BATTERY Please read and follow the handling instructions before using the battery. Improper use of the battery may cause heat generation, fire, explosion, damage, or capacity deterioration of the battery. WARNING 01.
TENTATIVE 05. Do not use any battery chargers not specified by the end product. Also, follow the charge conditions specified by the end product. If the battery is charged under other conditions (a high temperature, a high voltage/current, or an altered charger) not specified by the end product, the battery may become over-charged with an excessive current and cause heat, explosion, or fire with abnormal chemical reactions. 06. Do not use, charge, or leave the battery in a car under the blazing sun.
TENTATIVE CAUTION 01. Do not put the battery in a microwave, oven, or high pressure container. Sudden heat may damage the seal of the battery and may cause heat generation, explosion, or fire of the battery. 02. Do not leave the battery in a charger or equipment if it generates an odor and/or heat, color and/or shape changed, electrolyte leaked, or any other abnormalities.
