User Manual
Table Of Contents
- 1. Get to Know Your Arlo Pro 3 Camera
- 2. Get Started
- Connect your SmartHub to the Internet
- The SmartHub LED
- Use the Arlo app for installation and setup
- Insert the battery into your camera
- The camera battery
- The Arlo Pro 3 Camera LED
- Tips for optimal WiFi performance
- Magnetic mount
- Install the Arlo Outdoor Mount
- Connect your camera to the Arlo solar panel (sold separately)
- Your Arlo Pro 3 Camera’s field of view
- Position your camera to detect motion in specific areas
- Test motion detection
- Arm your camera to detect motion
- 3. Arlo Pro 3 Basics
- 4. Image Quality Features
- 5. Modes, Rules, and Alerts
- Modes
- Select a mode
- Mute Notifications
- Rules for modes
- Change motion sensitivity
- Automatically stop recording when motion stops
- Control whether the spotlight turns on when motion is detected at night
- Change audio sensitivity
- Manage alerts
- Schedule your camera rules
- Set up Arlo Geofencing
- Geofencing with multiple mobile devices
- Detect audio alarms with your Pro 3 Camera
- 6. Change Your Settings
- 7. USB Storage
- 8. Arlo Connect
- 9. FAQs and Troubleshooting
- 10. Rechargeable battery safety
11Get Started
Pro 3 Wire-Free Security Camera System
User Manual
Replace a Pro 3 Camera battery
You can leave the camera housing in place so the camera position stays the same.
1. Release the camera from the camera housing.
Press the button on the charging port underneath the camera. The camera clicks
as it disengages from the camera housing.
2. Pull the camera all the way out of the camera housing.
3. Remove the battery by pulling on it until it slides out of the camera.
4. Align the battery and insert it into the battery compartment.
The battery only inserts one way.
The LED on the camera blinks blue.
5. Insert the camera into the camera housing by pushing down on both the left and
right sides of the camera until it clicks into place.