Installation Guide

Installation:
10
5. Snap the formed cover in place
over the fitting. Adhere the
mating surfaces of the inner
arc joint with 520 or 520 BLV
Adhesive. Join the straight
pipe covering to the fitting
cover, making sure to coat
both the pipe-section butt sur-
face and the fitting-cover butt
surface.
Note: On screwed fittings, select
the proper template from section
4.b.1., page 11. Notice that the
screwed fitting cover templates
allow for the 1″ minimum overlap
on the straight pipe next to the
fitting. Remember to cement this
1″ overlap with 520 or 520 BLV
Adhesive by forcing the brush
between the two surfaces.
6. Allow the adhesive to dry until
dry to the touch but tacky
under slight pressure before
joining surfaces. Press sur-
faces firmly together to seal.
Application to Victaulic
Couplings
Make two donuts, and place on
both sides of the Victaulic
Coupling. Complete the fitting
cover by gluing the circumferen-
tial strip of sheet insulation over
the two donuts.
▲
45° ELL
CIRCUMFERENCE
TEMPLATE FOR
VICTAULIC
COUPLING
90° ELL
TEE
ARMAFLEX
DONUTS
▲
▲
6
5
Please note: For installing self
adhering SA Armaflex sheets and
rolls, refer to p.19.