Operation Manual
25
CHRONOGRAPH 2 EYE - MODEL 5021.D
Setting the time
1. Pull crown out to position 3 (the watch stops).
2. Turn crown until you reach the correct time.
3. Push crown back to position 1.
Setting the date
1. Pull crown out to position 2 (the watch continues to run).
2. Turn crown until yesterday’s date appears.
3. Pull crown out to position 3 (the watch stops).
4. Turn crown until correct date appears.
5. Continue to turn crown until correct time appears.
6. Push crown back to position 1.
Chronograph
• Theminutecountermeasures30minutesperrotation.
• Thecenterstop-secondmeasures60secondsperrotation.
Please note:
Before using the chronograph functions, please ensure that:
- the crown is in position 1 (= normal position).
- the two chronograph hands are precisely at zero position following activation of pusher B.
Should this not be the case, the positions of the hands must be adjusted (see the chapter
entitled “Adjusting the chronograph hands to zero position”).
Chronograph: Basic function
(Start / Stop / Reset)
1. Press pusher A to start the center stop-second hand.
2. To stop the timing, press pusher A again.
3. To reset the two chronograph hands to zero positioning, press pusher B.
A
B
CENTER STOP-SECOND
MINUTE COUNTER
SECOND HAND