Owner's manual

5. MAINTENANCE PROCEDURES

The WWZ Scope should always be stored in the supplied packaging, particularly in heated and venti-

lated rooms. To keep the device operational, please follow the instructions (below) regarding prepa-

rations preparations for storage. The battery should be stored separately from the device, and be

inserted into the battery compartment only when the device is being prepared for use. The presence

of both acids and alkalis near the device is not recommended.

While stored, your WWZ Scope should be protected from exposure to direct sunlight or extreme tem-

peratures.

WWZ SCOPE CLEANING PROCEDURES

1) Gentlyremoveanydirtfromthesight’sbodyusingaclean,softcloth.

2) Wipe external surfaces down (with the exception of optical surfaces) with a clean cloth that has

been moistened with pure water.

3) Dryallwetsurfaceswithadierentclean,drycloth.

4) Carefully remove any dirt from the optical surfaces using a lens brush.

5) To avoid scratches, optical surfaces must be cleaned using a clean cotton swab that has been slight-

ly dampened with pure alcohol. The glass should be wiped in circular motions starting from the center

and moving out towards the edge, without touching the barrel. Change the cotton swab as soon as it

becomes dirty.

EYEPIECE MAINTENANCE

Occasionally, you may have to clean the eyepiece of your Armasight WWZ Scope sight. After unpacking

the WWZ Scope sight, make sure that there is no dust or dirt on or in the eyepiece. If you do nd dust

or dirt on the eyepiece, you will need to remove them for cleaning. The body of eyepiece has two set

screws, which you will need to loosen rst. After loosening these screws, turn the eyepiece counter-

clockwise to separate it from the body of the device.

NOTE:

It is unnecessary to completely remove the set screws. To avoid losing these miniature screws,

leave them at least partially inside the body of the device.

CAUTION:

Only apply photographic lens cleaning tissues to the surface of the eyepieces. Avoid damaging

orleavingngerprintsonthelenses.Acanofcompressedairmaybeusedtoblowdustoofthe

lenses. Do not tip the can while spraying, as you may cause the propellant to freeze as it exits the

can. This may damage the glass and the tube phosphor screen.

PREPARATIONS FOR STORAGE

When preparing your WWZ Scope for storage, perform the following steps:

1) Verify that the sights are operating in accordance with all previously specied procedures.

2) Remove the batteries from the battery compartments.

3) Clean the sights and all accessories.

4) Place all components into the storage case.