User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety Precautions
- 3 Description
- 4 Handling
- 4.1 Checking the weapon system (weapon and wrist watch)
- 4.2 Adapting the weapon to the user
- 4.3 Inserting the batteries
- 4.4 The wrist watch functions
- 4.5 Preparing the weapon for use
- 4.6 Aiming and firing
- 5 Cleaning
- 6 Malfunctions and Remedies
- 7 Storage
- 8 Transport/Shipment
- 9 Disposal
- 10 Spare Parts and Repairs
31
iP1 SmartSystemiP1 SmartSystem
Check communication between wrist watch and weapon
To check the communication between wrist watch and weapon, hold the weapon in your hand (full
batteries must be inserted) so that the backstrap switch is actuated. The LED display will indicate
one of the following statuses:
• LED display lights up blue: No magazine inserted.
• LED display lights up red: Weapon not ready for firing.
• LED display lights up green: The wrist watch detects the signal from the weapon.
The weapon is ready for firing!
If this is not the case, remedy the problem following the troubleshooting guide in Chapter 6.
4.4.2.3 PIN entered incorrectly
If the PIN is entered incorrectly, "FAIL" appears on the display. After confirming this message with
button TR, the system returns to the weapon menu. From here the submenu for the input of the PIN
can be called up again by holding button TR depressed for 3 seconds.
In the second line of the display, a message now appears indicating that this is the second attempt
to enter the PIN.
OK
3 sec.
2
43
1
Display "FAIL"
Confirm with TR, to
the weapon menu.
Submenu:
Hold TR pressed for 3
seconds.
Enter PIN.
Correction: MR.
If the entered PIN was correct, the remaining time can now be set (see Chapter 4.4.2.2).