User's Manual

37
iP1 SmartSystemiP1 SmartSystem
4.4.5.3 Reset weapon
By resetting the weapon, the ID of the wrist watch and the code for the communication in the
weapon are deleted. Resetting is performed in the following steps:
• Enter the weapon PIN,
• Check of the weapon PIN by the weapon (weapon held in the hand, backstrap switch actuated,
empty magazine inserted).
After resetting the weapon, it has to be referenced again before it can be used further (see Chapter
4.4.5.4).
Enter weapon PIN
The function for entering the weapon PIN is called up via the weapon menu by holding the buttons
TL and BL depressed for 3 seconds. To enter the input mode, you then have to press button TR once.
The weapon PIN consists of 10 digits from 0 to 9 and is entered digit by digit by changing the dis-
played numbers with the buttons TL (+) and BL (-). Each digit has to be confirmed with button TR.
Starting situation is the standard display (see Chapter 4.4.1).
1x
3 sec.
3 sec.
OK
–
+
Weapon menu:
Press BR 1x
Function "Reset
weapon". Hold TL and
BL depressed for 3
seconds.
Input: TR 1x
Enter digits individu-
ally (TL and BL) and
confirm (TR).
Correction: MR
After last digit:
Weapon symbol
flashes, receiver ready.
After confirmation of the last digit, the receiver in the wrist watch is activated – the weapon symbol
flashes. The weapon must not be held in the hand (backstrap switch actuated) for communication
with the wrist watch. After detection of the weapon, the wrist watch transmits the weapon PIN to
the weapon.