User's Manual

iP1 SmartSystem – PersonalizediP1 SmartSystem

8 Synchronizing the time between the iP1 pistol & the iW1 wristwatch

The iP1 pistol will only be activated by the iW1 wristwatch when their system times are synchro-

nized. If the system times become unsynchronized, such as when the batteries in the iP1 pistol and/

or iW1 wristwatch are changed, or the system was not used for a long period of time, and the iP1

pistol is otherwise ready for use with the iW1 wristwatch:

• already referenced to the iW1 wristwatch;

• the correct PIN code has been entered in the iW1 wristwatch;

• the iP1 pistol is within 10” of the iW1 wristwatch;

• a magazine is inserted in the iP1 pistol; and

• the backstrap is actuated by squeezing it towards the front of the iP1 pistol

the display of the iW1 wristwatch will read “No SYnc” and the LED on the iP1 pistol will flash red. To

synchronize the time between the iP1 pistol and the iW1 wristwatch, complete the following steps:

1. If the iP1 pistol is loaded, unload it.

2. Insert an empty magazine in the iP1 pistol.

3. While holding the iP1 pistol within 10” of the iW1 wristwatch, actuate the backstrap by

squeezing it, while continuing to squeeze it, press the top left button on the iW1 wristwatch

once when the display reads “no SYnc.”

4. If iP1 pistol and iW1 wristwatch were successfully synchronized, the iW1 wristwatch will re-

turn to the standard display and the LED on the iP1 pistol will stop flashing.

5. If the “no SYnc” message continues to be displayed, stop squeezing the backstrap so the LED

on the iP1 pistol switches off, wait 20 seconds, and repeat steps 3-5.

6. If a flashing pistol is shown on the display, the synchronization was not successful. If you have

more than one iP1 SmartSystem – Personalized, make sure you are using the iW1 wristwatch

that is referenced to the iP1 pistol you are trying to synchronize.