User's Manual

34
iP1 SmartSystem – PersonalizediP1 SmartSystem
9 Changing / resetting the 5 digit PIN code using the 12 digit SuperPIN
If the PIN code entry was deactivated because an incorrect PIN code was entered three times in a
row when attempting to activate the iP1 pistol, or you want to change the PIN code, you can define
a new PIN code using the iW1 wristwatch and the 12 digit SuperPIN by completing the following
steps:
1. Beginning with the standard display, press the bottom right, bottom left, top right, and top left
buttons at the same time for 3 seconds, until “SUPErPIN” is shown on the display.
2. Press the middle right button to cancel, or any other button to begin entering the SuperPIN.
3. Enter the 12 digit SuperPIN by pressing the top left button for 1, the top right button for 2, the
bottom left button for 3, and the bottom right button for 4. If you make an error in entering a
digit, it can be corrected by pressing the middle right button. After the last digit of the Super-
PIN has been entered and the SuperPIN is correct, the display will read “PIN-1.”
If an incorrect SuperPIN is entered, the iW1 wristwatch will return to the standard display.
Repeat steps 1 through 3. If the incorrect SuperPIN is entered three times in a row, you will
have to wait ten minutes in the SuperPIN menu before attempting to enter the SuperPIN again.
4. Enter the new 5 digit PIN code you have selected by pressing the top left button for 1, the top
right button for 2, the bottom left button for 3, and the bottom right button for 4. If you make
an error in entering a digit, it can be corrected by pressing the middle right button. When the
fifth digit is entered, the PIN code is automatically accepted and the display will change to
“PIN-2.”
5. Re-enter the 5 digit PIN code you have selected by pressing the top left button for 1, the top
right button for 2, the bottom left button for 3, and the bottom right button for 4. If you make a