User's Manual

54
iP1 SmartSystem – PersonalizediP1 SmartSystem
19 Unloading procedure and safety check
• Do not uncock the iP1 pistol with a cartridge in the chamber. If you lose your grip on the
hammer while lowering it, the iP1 pistol may unintentionally discharge, possibly leading
to death or serious personal injury to you or others.
• Although the iP1 pistol has a loaded chamber indicator (LCI) you should never solely
rely on it or your memory to determine whether the iP1 pistol is loaded or unloaded.
Always retract the slide by grasping it at the indented area at the rear of the slide and
pulling it fully to the rear and then visually and physically (with your finger) check to
make sure there is not a cartridge in the chamber.
• Although the iP1 pistol has a magazine disconnect, it is electronically controlled and
could fail. Never rely on a magazine disconnect to prevent the pistol from firing when
the magazine is removed and always retract the slide by grasping it at the indented
area at the rear of the slide and pulling it fully to the rear and then visually and physi-
cally (with your finger) check to make sure there is not a cartridge in the chamber.
To unload the iP1 pistol, follow the instructions below. To ensure that the iP1 pistol is unloaded,
you MUST proceed in this order.
1. Secure the trigger by pressing the trigger switch to the left.
2. Remove the magazine by pressing down on the magazine release. (Note: To prevent damage
to the magazine, do not allow it to fall to the floor).
3. While holding the grip with your firing hand, with your finger off of the trigger and outside of
the trigger guard, grasp the rear of the slide at the indented area with your other hand and
pull the slide fully back to eject any cartridge that may be in the chamber.
4. Lock the slide in the rearward (open) position by pushing up on the slide lock and slowly re-
leasing the slide from the fully rearward position until it locks in the open position.