User's Manual

iP1 SmartSystem – PersonalizediP1 SmartSystem

3. While holding the grip with your firing hand, with your finger off the trigger and outside of the

trigger guard, grasp the rear of the slide at the indented area with your other hand and pull

the slide fully back to eject any cartridge that may be in the chamber.

4. Lock the slide in the rearward (open) position by pushing up on the slide lock and slowly re-

leasing the slide from the fully rearward position until it locks in the open position.

5. Once the slide is locked to the rear, both visually and physically (with your finger) inspect both

the chamber and the magazine well of the iP1 pistol to be sure that no ammunition remains

in either place.

6. Release the slide to return it to the forward (closed) position by either pressing the slide stop

lever down or grasping the rear of the slide at the indented area with your other hand and

pulling the slide fully back and then releasing it.

7. Press the cover release (the metal strip under the barrel in front of the trigger) upwards and,

while holding it in, pull the cover forward and away from the frame.

8. Pull the slide completely to the rear and then upwards to release it from the frame.

9. Push the slide forward and off of the barrel.

10. Pull the recoil spring forward off of the barrel.

In order to be able to remove the slide, the cover must

first be released and pulled off. To release the cover,

press the metal strip under the barrel in front of the trig-

ger upwards and pull the cover off the pistol from the

front.

PRESS

Release and pull off

cover.