Use and Care Manual

surfaces of your furniture, cleaning off any dirt.For extra cleaning power, mix 1/3 bleach and 2/3
water.Apply bleach mixture to furniture with a clean cloth and allow it to sit on the lumber for a
few minutes (this will not affect the color).Loosen any dirt and debris that may catch in the
surface grooves of the lumber by scrubbing the bleach mixture with a soft-bristle brush.Rinse
thoroughly.
Maintenance
Before installation, remember to keep your plywood dry and store in a protected area. Store
your plywood on a flat, dry surface with a cover sheet on top. Do not store your plywood
sideways as this will cause bowing. Avoid direct sunlight, wind, rain and humidity, all of which
can affect the appearance of your plywood.Do not use oil-based products on Hoop Pine
plywood.Take care in freestanding applications. Plywood is a natural product that can be
affected by changes in ambient weather conditions, possibly causing previously flat sheets to
bow are concerned. So better to keep plywood not under the strong sun.
Caring for Cushions
Deep Cleaning
Removable covers sometimes can be machine-washed in cold water, using mild, bleach-free
laundry soap, and then air-dried. To hand-wash, submerge the fabric in a solution of 1/4 cup
gentle liquid soap, such as Ivory, and 1 gallon lukewarm water (do not exceed 100 degrees),
swishing gently. Rinse, and air-dry. To clean mold from solution-dyed fabrics, mix 1 gallon warm
water with 2 tablespoons oxygen bleach if the care guide lists it as an approved cleaning agent.
Wet the affected area, and scrub with a soft-bristle brush. Rinse, and air-dry.
Maintenance
Regularly brush off dirt and debris, and rinse as needed. Wipe spills and stains immediately with
a wet cloth and a mild soap solution, because certain liquids, such as sunscreen, may cause
discoloration. Some fabrics have a water-repellent finish (check care guide) that loses
effectiveness over time. To restore repelled, clean and dry the material, and then apply a fabric
protector, such as 303 High Tech Fabric Guard (not suitable for vinyl or plastics). Let dry between
coats. Repeat once a year or whenever water stops beading on the surface.
FOR ANY PRODUCT RELATED QUESTIONS,
YOU MAY CALL OR EMAIL THE MANUFACTURER AT
818-767-6626
[e-mail]