User's Manual

2). Click controllers icon on the main menu, as below picture:
3). Select “change grip/order”，as below picture：
4). Click “change grip/order”to enter the pairing interface. Press and hold Docking button for 3
seconds to establish pairing, 4 LED indicators flash, release your hand, wait for 5-30 seconds until
pairing succeeds and controller icon shows up on the screen, corresponding channel LED indicator keeps
on.
12. Gyroscope sensor calibration:
In sleep state, press and hold L3, then press button R, LED indicators flash from left to right
in cycle, the controller enters calibration mode. Place the controller on a horizontal table, press
button +, 4 LED indicators illuminate and are off in 3 seconds, now calibration finishes and controller
comes back to sleep state.
13. Factory mode setting:
In sleep state, press and hold L3&R3, then press Docking button，4 LED indicators illuminate, the
controller enters factory mode setting.Controller comes back to sleep state after loosing the Docking
button. （Note: In factory mode, the function to awake up the controller by any button is closed, which
can avoid the controller is in connection state during packing and transport.)
14. Factory mode exit:
In factory mode, press Docking button on the back of the controller to power on it. Press and hold