TDS

SHELF LIFE
MIX RATIO
POT LIFE
SOLIDS BY WEIGHT
SOLIDS BY VOLUME
PACKAGING
COLORS
RECOMMENDED THICKNESS
COVERAGE
-
CURE SCHEDULE
FOOT TRAFFIC
LIGHT TRAFFIC
FULL CURE
BOARD RESISTANCE (PSI) ASTM D4541
PERMEABILITY (%), ASTM D570
HARDNESS (SHORE D), ASTM D2240
ABRASIVE RESISTANCE, ASTM D4060
(CS17/100 CYCLES/1000G)
VISCOSITY @ 77°F
TRACTION RESISTANCE (PSI),
ASTM D638
COMPRESSIVE STRENGTH
(PSI MPA), ASTM D6595
ELONGATION % ASTM D638
RECOAT WINDOW
@ 50 °F
@ 68 °F
@ 90 °F
12 MONTHS
2 PARTS A TO 1 PART B
40-50 MINUTES @ 77°F
100%
100%
3 GAL KITS. 2 GAL A, 1 GAL B
MEDIUM GRAY, LIGHT GRAY
6-12 MILS
200 SF PER GALLON @ 6 MILS THICK
100 SF PER GALLON @ 12 MILS THICK
-
16 TO 30 HOURS
2-5 DAYS
5-10 DAYS
> 300 (SUBSTRATE RUPTURES)
0.3%
85-90
0.10G
-
1200-1400
6500
-
14000
-
6.7
-
30 HOURS - 72 HOURS
24 HOURS - 48 HOURS
16 HOURS - 24 HOURS
PRODUCT DESCRIPTION
ARM707X-CM is a 100% solids epoxy coating that is solvent-less. It is a two component epoxy coating system. It exhibits
very good appearance and chemical and physical properties.
RECOMMENDED FOR: Recommended for a high build topcoat or basecoat on concrete or masonry. Product is suitable in
many chemical exposure environments.
ARM707X-CM
100% SOLIDS EPOXY COATING
BASE/BUILD
100% HIGH BUILDS SOLIDS EPOXY
Rev 11/21
CHEMICAL AND PHYSICAL ANALYSIS
ArmorPoxy Inc.
1260 North Ave
Plainfield, NJ 07062
armorpoxy.com
E: [e-mail]
P: 888-755-7361
RESTRICTIONS
Minimum/Maximum temperature of substrate: 50°F/86°F
Maximum relative humidity during application and curing: 85 %
Substrate temperature must be (5.5 ° F) above dew point measured.
Humidity content of substrate must be <4% when coating is applied.
Do not apply on porous surfaces where a transfer of humidity may occur during application.
Avoid exterior use on substrates at ground level.
Protect from humidity, condensation and contact with water during the 24-hour initial curing period
Surface may discolor in areas exposed to regular ultraviolet light
TECHNICAL DATA SHEET
ADVANTAGES
Dense surface resistant to bacteria and moisture and easy to clean // May apply
several layers on itself with excellent adhesion // Low odor product allowing for
interior application without harmful odors.
COMPOSITION
100% solids epoxy coating with no solvents and a very low VOC content (VOC =
88g/liters).
PACKAGING
Sold in 3 Gal Kits consisting of 2 Gal of Pre-Tinted part A and 1 Gal of Part B
COLOR
Available in Medium and Light Gray. For special orders please consult your sales
rep
CURE SCHEDULE TIMES ARE
APPROXIMATE AND WILL BE
AFFECTED BY TEMPERATURE
CONDITIONS AND RELATIVE
HUMIDITY
Chemical
Resistance
Super
Durable
Roll On
Application
100%
100% Solids
Epoxy
Safe To Apply
Indoors