Manual

ManualsBrandsArmscor ManualsFirearms1400TS

ARMSCOR

MODEL 1400 TS

USER’S MANUAL

WARNING:

READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS MANUAL

CAREFULLY BEFORE USING THIS FIREARM.

DISCHARGING FIREARMS IN POORLY VENTILATED AREAS, CLEANING

FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE TO

LEAD AND OTHER SUBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO

CAUSE BIRTH DEFECTS, REPRODUCTIVE HARM AND OTHER SERIOUS

PHYSICAL INJURY. HAVE ADEQUATE VENTILATION AT ALL TIMES. WASH

YOUR HANDS THOROUGHLY AFTER EXPOSURE.

INSTRUCTIONS FOR OPERATING AND CARE

This rifle is packed and shipped from the factory with the bolt assembly detached.

• TO INSERT BOLT INTO RECEIVER

Before putting the bolt into the receiver, check first if the bolt is cocked. If not, push bolt

into the receiver as far as possible, then rotate the bolt handle upward, thus cocking the

bolt. With the safety in “F” position and bolt cocked, pull trigger fully, insert bolt into

receiver and close fully. Turn bolt handle downward to lock.

• TO MAKE SAFE

Pull safety on right side of the receiver in the direction of the “S” mark. This locks

trigger and gun cannot be fired.

• TO OPEN ACTION

Rotate bolt handle upward (this cocks firing pin) and pull fully rearward.

• TO LOAD CARTRIDGE

At open action, insert cartridge directly into the barrel chamber.

• TO CLOSE ACTION

Push bolt handle fully forward and rotate downward.

Page 1 of 5

Summary of content (5 pages)

PAGE 1
ARMSCOR MODEL 1400 TS USER’S MANUAL WARNING: READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS MANUAL CAREFULLY BEFORE USING THIS FIREARM. DISCHARGING FIREARMS IN POORLY VENTILATED AREAS, CLEANING FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE TO LEAD AND OTHER SUBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS, REPRODUCTIVE HARM AND OTHER SERIOUS PHYSICAL INJURY. HAVE ADEQUATE VENTILATION AT ALL TIMES. WASH YOUR HANDS THOROUGHLY AFTER EXPOSURE.
PAGE 2
• TO FIRE Be sure gun is pointed towards target. With action closed, push safety to “F” position. Pull the trigger. Open action to eject discharge shell. CARE OF RIFLE After firing, wipe out bore with clean patch. If firearm is to be stored, use a good grade of gun grease or gun oil in the bore and the outside metal surfaces. Interior of barrel should be cleaned free of gun grease or gun oil before firing to ease passage of bullet and to prevent swelled bore, injury to barrel or person.
PAGE 3
Monte Carlo Style with Check Piece and Rubber Butt Pad Other Feature “Gold Inlays” on Barrel Markings Each rifle comes with group shots sample Specially made barrel with straight and concentric bore to outside diameter as drilled.
PAGE 4
Firing Pin 1425 Firing Pin Spring 1426 Firing Pin Spring Retainer Pin 1427 Firing Pin Spring Follower 1428 Firing Pin Cross Pin 1429A Hammer 1429 C- TRIGGER HOUSING ASSEMBLY Safety Latch 1233 Safety Latch Bearing 1233A Safety Latch Bearing Spring 1233B Safety Latch Pivot Pin 1234 Safety Latch Button 1235 Sear 1236 Sear Pivot Pin 1237 Sear Spring 1238 Sear Stop Pin 1239 Trigger 1240 Trigger Pivot Pin 1241 Trigger Spring 1242 Trigger Stop Pin 1243 Trigger Housing 1244 T
PAGE 5
Page 5 of 5