Manual

ManualsBrandsArmscor ManualsFirearms14P

ARMSCOR

MODEL 14P

USER’S MANUAL

WARNING:

READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS MANUAL

CAREFULLY BEFORE USING THIS FIREARM.

DISCHARGING FIREARMS IN POORLY VENTILATED AREAS, CLEANING

FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE TO

LEAD AND OTHER SUBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO

CAUSE BIRTH DEFECTS, REPRODUCTIVE HARM AND OTHER SERIOUS

PHYSICAL INJURY. HAVE ADEQUATE VENTILATION AT ALL TIMES. WASH

YOUR HANDS THOROUGHLY AFTER EXPOSURE.

INSTRUCTIONS FOR OPERATING AND CARE

This rifle is shipped from the factory with the gunstock packed separately from the

barrel receiver assembly and bolt assembly.

ASSEMBLY

Remove the screw from the stud on the underside of the barrel and directly opposite

the trigger housing. (Note that the stud can be moved sideways and is kept from sliding

out by staking the ends of the dovetail cut). Fit barrel-receiver and trigger housing

assembly to the stock such that the stud freely fits into the hole provided for it in the

gunstock. Tighten screw to nest barrel on the stock.

TO PUT BOLT INTO RECEIVER

Before putting bolt into receiver. Note first if bolt is cocked. If not, push bolt into

receiver as far as possible, then rotate bolt handle upward, thus cocking bolt. With safety

in “F” position and bolt cocked, pull trigger fully, insert bolt into receiver and close fully.

Turn bolt handle downward to lock.

Summary of content (7 pages)

PAGE 1
ARMSCOR MODEL 14P USER’S MANUAL WARNING: READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS MANUAL CAREFULLY BEFORE USING THIS FIREARM. DISCHARGING FIREARMS IN POORLY VENTILATED AREAS, CLEANING FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE TO LEAD AND OTHER SUBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS, REPRODUCTIVE HARM AND OTHER SERIOUS PHYSICAL INJURY. HAVE ADEQUATE VENTILATION AT ALL TIMES. WASH YOUR HANDS THOROUGHLY AFTER EXPOSURE.
PAGE 2
TO LOAD MAGAZINE Hold magazine firmly in one hand. With the other hand place cartridge on top just forward of notch and press head downward under ears at rear of magazine. Repeat until maximum number of cartridges is loaded. TO MAKE SAFE Pull safety on right side of receiver in the direction of the “S” mark. This locks trigger and gun cannot be fired. TO ATTACH MAGAZINE Position magazine open end up and ears rearward. Push magazine inward until it engages with magazine catch.
PAGE 3
CARE OF RIFLE After firing wipe out bore with clean patch, followed by oily patch if firearm is to be used again soon. If firearm is to be stored, use a good grade of gun grease in bore as well as outside. Interior of barrel should be cleaned free of grease before firing to ease passage of bullet and to prevent swelled bore or injury to barrel. Always keep cocking cam in bolt assembly slightly oiled.
PAGE 4
Ordnance Steel Precision Rifled Barrel Six (6) Grooves, Right Hand Twist Positive Thumb Operated Safety PART NAMES PART NOS.
PAGE 5
Extractor Spring 1424 Firing Pin 1425 Firing Pin Spring 1426 Firing Pin Spring Retainer Pin 1427 Firing Pin Spring Follower 1428 Hammer 1429 Firing Pin Cross Pin 1429-A C – TRIGGR HOUSING ASSEMBLY Magazine Catch Insert 1430-A Magazine Catch 1430 Magazine Catch Pivot pin 1431 Magazine Catch Stop Pin 1432 Safety Latch 1433 Safety Latch Bearing 1433-A Safety Latch Bearing Spring 1433-B Safety Latch Pivot Pin 1434 Safety Latch Button 1435 Sear 1436 Sear Pivot Pin 1437 Sear Sp
PAGE 6
Magazine Box 1447 Magazine Spring 1448 Magazine Spring Follower 1449 Magazine Spring Retainer 1450 Magazine Spring Retainer Cross Pin 1451 E – GUN STOCK ASSEMBLY Butt Plate (Plastic) 1452 Butt Plate Retainer Screw 1453 Gun Stock.
PAGE 7