Manual

Step 8) With the use of extra long and heavy-duty screw driver, swing out the
butt plate and insert the screw driver into the hole of the butt stock and loosen the
stock bolt (Part #3046) which is inside the butt.
Step 9) Now you can separate the butt stock from the rifle.
Step10) Loosen out the three (3) screws in the receiver cover right side. Then
separate the left side receiver cover the rifle assembly together with right side
receiver cover.
Step11) Now, separate rifle assembly from the (right side) receiver cover by
lifting the rifle up and away (muzzle end first) from the receiver cover.
Step12) Punch out trigger stop pin (Part #1648) and Trigger pin (Part #1647).
Step13) Unscrew the two (2) hold down screws of the trigger housing (Part #
1658&1657). The trigger housing assembly can not be separated from receiver-
barrel assembly. Carefully take note of the trigger spring and follower located at
the rear end of trigger housing. It is small that it may get lost.
Step14) Unscrew receiver cap lock screw (Part #1618).
Step15) Loosen out the receiver cap. Be careful in removing receiver cap as it is
under pressure by compressed spring inside.
Step16) The spring assembly and the bolt can not be removed from the receiver.
Keep the parts in the same order you have taken them out of the receiver to avoid
confusion in reassembly.
Step17) The barrel, receiver and action should be cleaned in solvent (or any
equivalent cleaning oil), dried and oiled lightly prior to reassembly.
CAUTION: Further disassembly of the action, and of the sights (front &
rear) are not recommended and should only be attempted by a competent
gunsmith or authorized service center.
Step18) To reassemble, insert the bolt & firing pin (bolt face end first) into the
receiver, then followed by the spring assembly unit. Then insert firing pin spring
/ spring guide into the bolt rear center hole, insert recoil spring guide sleeve,
recoil spring and recoil spring retainer sleeve (in that order) and finally, the
receiver cap.