Use and Care Guide

Cleaning Methods

A – A commercial vacuum system with 100-inches/H2O vacuum capacity is recommended for removing dust

particles. The vacuum system cleaning attachment should be a 3" diameter wand with natural hair bristle.

A HEPA vacuum filter is recommended to minimize air borne dust during the cleaning process. Care must

be taken while vacuuming to avoid excessive pressure. Use a blotting action to minimize potential loss of

surface texture.

B – Using a damp cloth or sponge with a mild detergent, wipe lightly on surface of board to remove dirt.

C – Use a mild household cleaner like fantastik

and a soft cloth. Before cleaning the grid, remove the ceiling

panels to prevent cleaning solution or dirt from getting on the panels.

D – Abrasive or strong chemical detergent should not be used. A mild detergent diluted in warm water, applied

with a soft cloth, rinsed and finally wiped off with a chamois will maintain the ceiling in good condition. Oily or

stubborn stains, if not removed by washing, can be wiped with products like fantastik

, but care is necessary

to avoid affecting the gloss level of the paint finish.

E – Use a clean, dry, soft, white cloth to wipe off any dirt or greasy fingerprints. If this does not clean the panel,

use a damp, clean, soft, white cloth or sponge with a mild detergent to wipe the panel.

F – Use a feather duster or vacuum to remove dust from colored products (See note***).

G – Use a damp cloth, sponge, or soft-bristled brush with water and mild, clear detergent or disinfectant. Gently wipe

or scrub the panel surface with medium pressure. Lightly spray panels with a clear cleaning agent or clear

disinfectant and wipe clean with a dry cloth.

H – Use a clean, dry, soft, white cloth to wipe off any dirt or greasy fingerprints. If this does not clean the panel,

use a damp, clean, soft, white cloth.

– Where “mild, clear detergent” is referenced use a clear dishwashing liquid.

– Where “clear disinfectant” is referenced use sodium hypochlorite, isopropyl alcohol, hydrogen peroxide, or quaternary ammonium.

– For greasy stains use products like clear fantastik

*** We do not recommend the use of any cloth either wet or dry because using pressure (rubbing) to clean the finish will result in “burnishing”

(or polishing) of the color, which will appear like streaking because of the gloss level change.

RC-3903-221

All other trademarks used herein are the property of AWI Licensing LLC and/or its affiliates

ceilings.com

CLEANING GUIDELINES

Armstrong

Ceiling Panels & Suspension Systems Products

Effective December, 2020