Use and Care Guide

quality commercial floor stripper
recommended for use on vinyl or vct .
NOTE: The use of aggressive strippers
such as mop-on/mop-off, no-scrub and
no-rinse strippers is not recommended
on tile floors less than two years old
because they may affect the adhesive
bond.
2. Thoroughly rinse the entire floor with
fresh, clean water. Remove rinse water and
allow it to dry completely.
3. Apply 3 to 5 coats of high-quality
commercial floor polish such as Armstrong
S-480 Commercial Floor Polish. If the floor
has been stripped, the application of a stain
resistant sealer such as Armstrong S-495
Commercial Floor Sealer, prior to the
application of polish, is recommended in
areas that will be exposed to heavy traffic
and/or staining agents.
B. Daily/Regular Maintenance
1. Sweep, dust mop or vacuum the floor
daily to remove dust,
dirt, grit and debris that
can damage the floor and become ground
into the surface.
2. Spot mop as needed. Any spills should be
cleaned up immediately.
3. Damp mopping of the floor should be
performed on a regular or daily basis
depending upon traffic and soil levels in the
space. Use a properly diluted neutral
detergent solution such as Armstrong S-485
Commercial Floor Cleaner.
C. Periodic Maintenance
1. When needed, machine scrub the floor
with a properly diluted neutral detergent
solution such as Armstrong S-485
Commercial Floor Cleaner and the
appropriate scrubbing pad (red for light
scrub, blue/green for a deep scrub) or
equivalent brushes.