Submittal Sheet

Job:
Engineer:
Contractor:
Representative:
Ordered by: Date:
Submitted by: Date:
Approved by: Date:
File No: 10.50
Date: dec. 17, 2013
Supersedes: 10.50
Date: july 25, 2012
pump design data
materials of construction
SERIES S
|
STANDARD CIRCULATORS
|
SUBMITTAL
maximum pump operating conditions
optional equipment
performance curve
125 psig at 225°f (863 kPa at 107°c)
Pump model: Flange size:
No. of pumps: Note:
Capacity: USgpm (L/s) Head: ft (m)
Temperature: °f (°c) Liquid:
Companion flanges: Included
part name bronze fitted lead free bronze*
Pump Body Cast iron Lead free Bronze
Impeller: Non-ferrous
Bearings:  Sleeve - Oil lubricated**
 'Maintenance free' bearings - No lubrication***
Seal: Mechanical
Stationary seal face: Sintered silicon carbide
Coupler: s25-s46: Flexible, 4 - Spring;
s55-s69: Flexible spacer type
Motor: Single phase - 1800 rpm - Resilient mounted
Three phase - 1800 rpm - Resilient mounted
Based on 1800 rpm, 60 Hz motors. For 50 Hz motors write for special capacity charts.
flow - usgpm
flow - l/s
head - feet
head - meters
0 0.63 1.89 3.15 4.41 5.68 6.94 8.20 9.4610.73
01030507090 110 130 150 170
0
5
10
15
20
25
30
35
40
0
1.5
3.0
4.6
6.1
7.6
9.1
10.7
12.1
S2
S4
S3
S5
S4
S6
S5
preferred selection area
p
e
a
Based on 1800 rpm, 60 Hz motors.
For 50 Hz motors write for special capacity charts.
* Contains less than 0.25% lead, weighted average.
** Alloy shaft with copper sleeve.
*** Stainless steel shaft.