Use & Care Guide

Armstrong

S-403 Excelon Floor Polish

Use and Care

Use For:

• All Armstrong commercial vinyl floor coverings except Safeguard, Safeguard Spa,

Safeguard Design, Safeguard Hydro and Excelon SDT

• Asphalt and rubber tile

• Linoleum

• Ceramic - although not of much value on glazed ceramic

• Slate, terrazzo, concrete and brick although other products are designed for better

results

Do Not Use For: Wood and marble

FLOOR PREP - FIRST COAT:

• Strip floor using any high quality stripper designed for vinyl floor coverings

• Rinse thoroughly

• Let floor dry

FLOOR PREP - RECOATING:

• Sweep or vacuum thoroughly

• Scrub with Armstrong Excelon Floor Cleaner (S-401)

• Rinse thoroughly

• Let floor dry

POLISH - LOW TRAFFIC:

• Apply 3 to 5 coats (do not apply more than four coats of polish at one time; wait a minimum

of 24 hours before applying more polish)

• Pour polish into a clean bucket (never pour polish directly onto floor)

• Use a clean finish mop (rayon) or finish applicator

• Let dry 30 minutes between coats

POLISH - HIGH TRAFFIC:

• Follow instructions above for Low Traffic; then

• High speed burnish

• Spray buff (spray-buff solution one part S-403 to two parts water)

• Apply 1 or 2 extra coats

PAGE 1
Armstrong® S-403 Excelon Floor Polish Use and Care Use For: • All Armstrong commercial vinyl floor coverings except Safeguard, Safeguard Spa, Safeguard Design, Safeguard Hydro and Excelon SDT • Asphalt and rubber tile • Linoleum • Ceramic - although not of much value on glazed ceramic • Slate, terrazzo, concrete and brick although other products are designed for better results Do Not Use For: Wood and marble FLOOR PREP - FIRST COAT: • Strip floor using any high quality stripper designed for vinyl floor cove