Product Manual

11. Your clamps can be partially pre-assembled.

The clamp assembly that mount to your unit may be

oriented horizontally or vertically.

13. Notice how crossbar will sit in clamp assemblies once

clamps are mounted on unit.

NOTE: If the controls on your snow thrower require more

space for proper operation,  ip bar J.

Make sure open end

of crossbar is facing up. Be sure end with tab is facing

down.

12. To determine the general location and direction for

the crossbar (J), have an assistant hold the cab at the

desired location over the unit.

NOTE: Depending on your unit, the crossbar may be

positioned facing forward or backward, and above

or below any linkage.

14. Holding crossbar (J) in desired location, select area

to mount K & L clamp assemblies . See Fig. 12.

NOTE: Brute and John Deere units may require you to

mount to the horizontal handlebars on the unit.

NOTE: Preferred position is on the vertical portion

of the unit’s upper handlebars.

Lower Handle Bars

(Horizontal Tube Mount)

Upper Handle Bars

(Vertical Tube Mount)

Upper vertical

handle bars

Lower horizontal

handle bar

Crossbar (J)

The preferred orientation of the clamp assembly is to

have the saddles perpendicular to one another. Thread

the small bolt P into the center of K & L assemblies,

 nger-tight. Slide smaller tube, L, into larger tube, K.