User manual

USER MANUAL
39
T r o u bles h ooti n g :
Display indication
Possible cause
Remedy
Initial heating Td
temperature exceeds
105°C, the sensor
does not react when
touched with a finger
The temperature sensor is
damaged .
Contact an authorised service
poin t.
Initial heating Td
temperature does
not reach 105°C
during 3 minutes
time, the halogen
heater(s) do not light.
The heater is damaged.
Replace the heater.
"Test ..."
Auto-tests in progress /
electronic unit damage
wait for 1 minute
" - - - - "
The moisture analyzer is
during zeroing
/ mechanical damage
wait for 1 minu t e
check if the moisture analyzer
is placed on stable ground, no t
affected by vibra t ions
„Tare range
exceeded”
Tare key pressed during zero
indica t ion
Moisture analyzer indica t ions
must be different than zero
„Zeroing range
exceeded”
Permissible zeroing range
was exceeded
Remove the load from the pan
„Weighing range
exceeded”
Permissible weighing range
(Max +9e) was exceeded
Reduce the load
„Measuring range
exceeded (+)”
Upper limit of analog-digi t al
transducer measuring range
was exceeded
Remove the load from the pan
„Measuring range
exceeded (-)”
Lower limit of analog-digi t al
transducer measuring range
was exceeded
Check if there are all necessary
pan elemen t s