User's Manual

27
5.4. Operation mode
Before switching to operation mode, check all connections between PA and TCVR.
We are back in the Main display, bar
graphs were defined, antennas were
preprogrammed, CAT was set. We are
ready to go to the operation mode.
Press shortly black STBY/OPER
button on the front panel.
We are in the operation mode.
Press MENU.
Now try to press PTT (foot switch for
example).
We are in the transmit mode (without
RF).
We have new button here. M-TUNE.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.