User's Manual

Exhibit 6 page 6 of 33
2. SAFETY INSTRUCTIONS
WARNING!
DANGEROUS HIGH VOLTAGE!
The power amplifier is using high voltage up to close 3000V DC, which is very
dangerous for human life! Read next safety instructions carefully first, before you will
start to install and operate power amplifier! NEVER VIOLATE NEXT RULES!
WARNING! NEVER ALLOW CHILDREN to play around PA or to touch power
amplifier or connected cables in working condition, or to push anything into the case
holes!
WARNING! The amplifier contains high voltage circuits. Never turn the amplifier on
without the upper lid in place. DO NOT ATTEMPT TO SHORT OR BYPASS safety
switch under upper lid!
WARNING! The OM2500A amplifier is neither to be used in a WET or HUMID
environment nor to be exposed to RAINFALL!
WARNING! Do not turn the amplifier on without having connected the ANTENNA or
properly rated DUMMY LOAD! A hazardous HF voltage may build up on the antenna
connector after turning the amplifier on with no antenna or dummy load connected!
WARNING! Before opening the upper lid of the amplifier make sure that power supply
has been disconnected AT LEAST 10 minutes allowing the electrolytic capacitors to
discharge fully. Disconnect power cord from the outlet!
CAUTION! The amplifier must be installed in such a way that free flow of hot air from
the tube is allowed. The amplifier must not be installed in a constrained surrounding
(i.e. tight shelves etc.)
CAUTION! The amplifier must be properly grounded during operation.
CAUTION! During operation the amplifier must be installed in such a way that the rear
power supplies are accessible.
CAUTION! The amplifier is an A category product. In a household it can influence
other electric appliances. In such cases the user is to take proper actions to mitigate this
disturbance.
CAUTION! Make sure that all screws holding the case together are properly in place
and tightened before carrying the amplifier with the handles.
CAUTION! Read this manual carefully. Fallow all of instructions during installation
and operation to avoid damage to the amplifier not covered by manufacturer´s
warranty! Do not attempt to perform any change of hardware or software!