User Guide

Once back in the compartment, arrest the take-up guide arm in it's latch near the
top of the magazine casting. Attach the film to the collapsible core by slipping it
into the gap and locking it with the chromed expansion clip.
During unloading, when using a collapsible center core, the film can easily
unspool from the center unless it is deliberately held. It is recommended
that a plastic core be inserted before repacking the film for the lab. By
twisting the plastic core a few turns in the direction of the film wind it will
"grab" the trailing end of the film and hold securely.
Collapsible Core Standard Core Core Adapter
Each one of the core adapters is easily interchangeable by depressing the
buttons at the ends of the film spindles. A standard core adapter can be
substituted for the collapsible one on the take-up side. In this case, a regular
plastic film core would have to be used on the take-up side as well.
Once the film loading procedure is
completed, close the magazine by
engaging the two location prongs on the
bottom of the cover in the corresponding
grooves of the magazine casting. Then
lay the cover flush against the magazine
and turn the lock clockwise until the
safety latch "clicks" into position.
Important Points To Check
Attach the film on the supply and take-up cores so it will run freely without
"wobble" inside the guide arm rollers.
Be sure to release both guide arms before closing the magazine cover. The
supply guide arm activates the film supply counter on the outside of the
magazine! If not released, the counter will not indicate.