User Manual

122 Camera Controls
Center mark Select to set the Center mark to Off, Small Dot, Medium
Dot or Cross to aid in image framing.
User rectangles Select to display up to two additional user-editable rec-
tangles in the EVF-1 image.
Edit user rectangles Select to adjust the user rectangles.
Framelines color Select to set the color of the frame lines.
Framelines intensity Select to set the brightness of the frame lines.
13.3.2 Viewfinder CAM menu
Press the CAM button to open the Viewfinder CAM menu in the EVF-1 display and set
camera parameters. Use the jogwheel on the EVF-1 to select and set menu options.
Press the CAM button to exit the Viewfinder CAM menu.
FPS Select to set the sensor frame rate. Preconfigured and previously
added user-defined values can be selected in the FPS list.
SHUTTER Select to set the shutter angle. Preconfigured and previously
added user-defined values can be selected in the Shutter list.
EI Select to set the exposure index. Settings from EI 160 to EI 3200
can be selected, in steps of 1/3 stop.
WB Select to set the white balance. Preconfigured and previously
added user-defined values can be selected in the WB list.
13.4 Web Remote
All ALEXA cameras contain a web server that can provide a user interface for
remotely controlling the ALEXA.
Connecting to the Camera
The Web Remote can be accessed through an Ethernet connection from the
camera's ETH port to a computer's Ethernet port, using the Bonjour protocol or
by directly entering the camera's IP address. First, make sure on the camera that
MENU>SYSTEM>NETWORK>Web remote ready-only is set to Off. If you want to
prevent access to the Web Remote, set MENU>SYSTEM>NETWORK>Web remote
ready-only to On. Then connect the cable. To use the Bonjour protocol, open the web
browser on the computer and enter the address alexa####.local in the browser's
address bar, with #### being the serial number of the camera. Alternatively, you can
look up the camera's IP address (INFO > SYSTEM) and enter that in the browser's
address bar.