User Manual

Appendix 185
Re-jam timecode now. Accuracy of jammed Timecode has expired.
Re-jam camera with external Timecode.
TC source forced to internal Sensor fps does not match Project fps. Exter-
nal Free Run TC cannot be used, camera has
switched to Int Rec Run TC.
TC mode forced to Rec Run Sensor fps does not match Project fps. Exter-
nal Free Run TC cannot be used, camera has
switched to Int Rec Run TC.
Interface bit error. Check im-
age.
Reboot camera. If error continues to occur,
contact ARRI service.
Internal processing problem Reboot camera. If error continues to occur,
contact ARRI service.
Internal battery error The internal battery which powers the real-time
clock must be replaced. Contact an ARRI ser-
vice center near you.
System problem Reboot the camera. If error continues to occur,
contact ARRI service.
System problem (I2C bus er-
ror)
Problem on camera data bus. Reboot the cam-
era. If error continues to occur, contact ARRI
service.
External TC: Incompatible
frame rate
The external TC signal's time base is not ac-
cepted by the camera.
HD outs not synced. Trigger
now.
Appears on slave cam with Ext sync activated,
but not using settings sync. Send trigger from
Ext sync master camera to ensure the MON
OUTs of both cameras are in sync.
Connect with Ethernet slave. Camera is set to Settings sync: ETH master,
but is not connected with slave camera via Eth-
ernet
Connect with Ethernet master. Camera is set to Settings sync: ETH slave, but
is not connected with master camera via Ether-
net
External TC: Jamming. Please
wait.
Camera jams to external TC signal. Do not dis-
connect TC source from camera until warning
disappears.
External TC: Signal missing Camera is set to Ext LTC regen, but external
TC signal is missing.
External TC: Incompatible
frame rate
The external TC signal has a time base that
does not match the project fps of the camera.
Framegrab: Grabbing image
failed
A problem occurred in the camera. The frame
grab failed.