User Manual

186 Appendix
Framegrab: Storing image
failed
A problem occurred with the SD card. The
frame grab failed.
Playback failed The camera could not play back the internally
recorded clips.
EVF smooth mode not possi-
ble
Smooth mode is set to "On", but either sensor
fps is higher than 30.000, or shutter angle is
higher than 180.0
Ext LTC: Forced to JAM sync Ext LTC had to be switched to Jam sync by
camera system.
Card/Media removed, play-
back failed
Camera had to abort playback, as media was
removed.
Calibrate lens motors. New lens motors are attached to the camera.
Prior to use they must be calibrated.
Temperature at limit. Fan
RPM raised
Although camera fan is in "Rec low" mode, fan
noise might exceed silent level because cam-
era is becoming too hot.
Master/slave: Focus unit mis-
match
With ALEXA SXT Plus and 3D lens sync, both
cameras must have same focus unit activated,
which is not the case here.
Slave: No lens table active. With ALEXA SXT Plus and 3D lens sync, select
lens table on slave when using LDA.
Sensor in High Humidity mode Reminder for active High Humidity mode
ND filter stuck ALEXA SXT Studio only.
ND filter slider has mechanical problems.
Mirror sector problem ALEXA SXT Studio only.
Mirror sector has mechanical problems.
Mirror cannot reach sync
speed
ALEXA SXT Studio only.
Mirror cannot reach speed due to technical
problems.
Voltage too low for mirror ALEXA SXT Studio only.
Power supply voltage level insufficient to drive
mirror shutter.
Mirror out of phase ALEXA SXT Studio only.
Mirror shutter and sensor are out of phase, may
result in exposure artifacts.
Mirror failure. Press GATE or
VIEW.
ALEXA SXT Studio only.
Mirror shutter initialization failed, press GATE or
VIEW to reset mirror shutter manually.