User Manual

Camera Controls 71
Any value in a list may be set. Invalid values will appear grayed out.
To set a list value:
1. Rotate the jogwheel to select the desired list value.
2. Press the jogwheel to set the list value.
Adding a list value
If the desired list value does not appear in the list, a user-defined value can be added.
To add a list value:
1. Press the ADD button.
2. On the ADD screen, use the jogwheel and + or – buttons to enter a new list value.
3. When you are finished entering the new list value, press the jogwheel to add it to
the list.
NOTICE
Each list supports a maximum of 16 entries. To add new user-defined list values to
a full list, you must delete previously added user-defined list values.
Deleting a list value
User-defined list values that are no longer required can be deleted.
To delete a list value:
1. Press the DELETE button.
2. On the DELETE screen, use the jogwheel to select the user-defined value you
wish to delete.
3. Press both DELETE buttons simultaneously.
NOTICE
Preconfigured values cannot be deleted and will appear grayed out on the DELETE
screen.
Figure 23: DELETE SENSOR FPS screen
NOTICE
The EI list is static and cannot be changed by the user. It contains ASA values from
160-3200 ASA in steps of 1/3 stop.
13.1.3.2 FPS
Press the FPS (frames per second) button on the HOME screen to open the SENSOR
FPS list screen, which lists the default frame rates as well as user-defined frame rates.