User Manual

Camera Controls 83
13.1.4.1 TC
Press the TC button to open the TIMECODE screen. The TIMECODE screen displays
the current timecode and timecode format settings.
Fig. 31: Timecode screen
NOTICE
Individual frame values are not shown but are still counted.
Press the SET TC button to set the TC counter (only when the timecode source is set
to Int TC). On the SET TIMECODE screen, press the SET 2 TIME button to match
the counter to the camera’s system clock. Press the RESET button to reset counter to
zero.
The PROJECT button is a quick link into the PROJECT menu screen, where project
fps can be adjusted. Project fps sets the time base of the time code.
TIMECODE OPTIONS
Press the OPTIONS button to open the TIME CODE OPTIONS screen.
Select Source to choose the timecode source. Available sources are:
Int TC Internal TC counter
Ext LTC TC is read from the LTC input. Only possible with Mode set to
Free Run, and the project frame rate must match the sensor
frame rate.
Select Mode to define how the timecode is counted. Available modes are:
Rec Run TC will only run while recording. The TC value increases with
every frame generated by the sensor while recording in the
project time base.
Free Run TC runs free. If the source is set to Int TC, and the sensor frame
rate does not match the time base of the TC, the value counts up
with every new frame generated by the sensor in the project time
base.
Select Generator to set the camera’s timecode generator. Available generators are: