User Manual
Camera Controls 85
Fig. 32: USER BITS screen
NOTICE
•
On HD-SDI out, the last two digits of the user bits contain the Variflag, therefore
the last two user bits cannot be set by the user.
•
User bits are not stored in user setup files. When loading a user setup file, they
are reset to 00:00:00:00.
•
Check user bits after changing the sensor mode.
13.1.4.2 INFO
STATUS Info
The STATUS INFO screen displays information about the current state of the camera
system. System state: Good means that all components in the ALEXA are functioning
normally. Other messages can contain error messages prefixed with E:, or warnings
prefixed with W:. For more information about error messages and warnings, see
"Warning and Error Messages" in the Appendix.
Press the SAVE TO SD button to save a system log to the SD card. This may take up
to one minute.
NOTICE
It is only necessary to save a system log if the camera experiences multiple error
messages or other abnormal behavior. The system log is not a human-readable file
and should be sent to an ARRI Camera Service center for analysis.
VERSION Info
Cam serial
no.
The serial number of the camera.