User Manual
Home screen and camera menu 107
3. For the selected clip, clip properties are displayed below the cliplist:
°
Codec: Recording codec of clip.
°
Resolution: Recording resolution of clip.
°
Duration: Clip duration at playback speed.
°
Rec FPS: Sensor frame rate the clip was recorded with.
°
Project rate: Playback frame rate of clip.
°
TC: Start timecode of the clip.
4. To load the selected clip: Press the jogwheel.
5. To return to the play screen without loading a new clip: Press BACK.
6. To end playback: Press EXIT.
OPTIONS
► Press the OPTIONS button to open the playback options screen.
You have the following options:
°
Play end mode
Define the playback behavior at the end of a clip.
•
Pause on end
Playback pauses at the end of the clip.
•
Pause on start
Playback pauses at the beginning of the clip.
•
Loop
Playback continues from the beginning of the same clip again.
•
Play next clip
Playback continues with the next clip in the cliplist.
•
Exit playback
Camera exits playback.
°
Monitor waveform
Sets the waveform overlay on monitor to On or Off.
7.10 System
The system menu organizes the general camera setup.
► Choose MENU > System.
7.10.1 Sensor
7.10.1.1 Adjusting the image sharpness
You can adjust the image sharpness ranging from -5 to +5 (default = 0). The image
sharpness influences the image detail. For more information, see "Adjusting the image
detail set/active", page 108
► Choose MENU > System > Sensor > Image sharpness set/active.